|
|
|
 |
Bowls Products |
Evergreens artificial grass bowls surfaces are ideal for the upgrading of any ditch base or back board. Our artificial grass surfaces are all U.V. stabilized and are pre-cut to your own requirements by our automated cutting table to ensure precise cutting. This page shows the surfaces we recommend for bowls ditch use. Evergreens also offer a fitting throughout the UK, which is a cost effective way of taking the strain out of fitting any of our surfaces. Request artificial grass samples and prices |
||
 |
 |
 |
Need help on fitting ?
Fitting instructions at the bottom of this page |
||
 |
 |
 |
 |
Meadow Twist Emerald Pile Height: ± 9mm Colour: Emerald Type: 100% Polypropylene Tufted / Curled |
Springfield Curl Pile Height: ± 6mm Colour: Emerald Type: 100% Polypropylene Tufted / Curled |
Grass Park Junior Pile Height: ± 14mm Colour: Olive Type: 100% Polypropylene Tufted / Curled |
Dimpled Rubber Ditch Base Product Available in:- 25/7mm 20/12mm 15/9mm |
| Fitting Tips and Suggestions. * Tools you need:- Trowel, Gloves, Stanley Knife, Brush, Float * You will also require boards and pegs to hold the surface in place while the adhesive cures * The pegs are made by cutting roof batten into pieces 2-3 inches wider than the ditch with a corner cut off one end. * Before you start sweep out your ditches and clean any debris from the back board. Place you boards on the edge of the green,(fig.2) then roll your new surface face down onto the boards. * Carefully trowel the adhesive on the back board for approximately three metres ( fig.2 ) * Carefully lift surface to back board. One person is to hold the start of the surface and the second person is to slightly pull on the surface to remove folds and ripples, now using a float or block of wood rub the surface hard to remove air and to make the surface contact the adhesive ( fig.3 ) * Place your boards against the surfaces and hold in place using the pegs ( fig.2). Now repeat the above steps around the rest of your ditch. |
||
(fig 2.) |
(fig 3.) |
 |
| The above tips are the most common way of fitting, In some conditions it may not be possible to do so. Please check before starting any work. If You require further information please call our office and ask for technical support on 01572 768208 or email sales@evergreensuk.com | ||
| |
| |
| |
| |
Evergreens
UK LTD
- Synthetic
Grass & Entrance
Mats
Extons Units, Market Overton Ind Est, nr Oakham, Rutland. LE15 7PP
Tel: 01572 768208 Fax: 01572 768261 Email: sales@evergreensuk.com
URGENT 24HR ORDER LINE 07889 441970